iPhone 17 Pro and 17 Pro Max restarting every 3 minutes
If your iPhone 17 Pro or 17 Pro Max restarts about every 3 minutes, often with a short pink or purple flash, its power controller (SMC) has lost one of its sensors. The panic log names which one - here is what each code means on this model, how sure repair technicians are, and what real repairs showed.
What the panic log says
Open the newest panic-full file (Settings → Privacy & Security → Analytics & Improvements → Analytics Data). On an iPhone 17 Pro or 17 Pro Max the important line looks like this:
The number that is not zero is the sensor code. Newer iOS versions print it in decimal: 524288 is the same as 0x80000. The table shows both.
Sensor codes on iPhone 17 Pro and 17 Pro Max
| Code | Part | Confidence | Sources |
|---|---|---|---|
0x6000006291456 | USB-C charging port flex, or the air-pressure sensor plugged into it | Medium - one reference so far | Repair Wiki |
What repairs showed
- Checks (Repair Wiki): the charging port flex and the air-pressure sensor plugged in; no torn or liquid-damaged flex; test with an original or premium part. The wireless charging flex on the back glass must also be plugged in. Repair Wiki
- Do not borrow codes from older models: on a 14, 0x600000 means wireless coil + front sensor; on the 17 Pro Repair Wiki reads it as the charging port flex. Repair Wiki
- No confirmed repair story yet for the 17 Pro - if yours gets fixed, post the code and the part on the forum.
Test order
- What was repaired last? A screen, battery, charging port or back-glass job is the first suspect - the part fitted, or a cable disturbed during it.
- Inspect the flex and its connector under magnification: torn traces, liquid marks, a bent pin.
- Test with a known-good original part plugged in. Unplugging the cable does not test it - an unplugged sensor is missing too, so the phone still restarts.
- Expect side effects: a replacement front sensor flex loses True Tone and auto-brightness; a battery or back glass that is not paired with Apple's System Configuration shows a parts message.
- If a good part does not stop it, the fault is on the logic board (often after liquid damage) - micro-soldering.
- Do not restore iOS for a hardware code. An SMC panic happens below iOS; restoring only costs time and, without a backup, your data.
Not the same problem
- A purple screen that stays, or purple lines without restarts, is usually the screen itself.
- Restarts at random times without
SMC PANICin the log are a different panic - the analyzer reads those too. - The phone will not update or restore (error 4013, 9, 75...): see the restore error lookup.
Sources
Different code, or still restarting after the part swap? Post your panic log on the NoPowerFix repair forum - board-level technicians answer, and every confirmed fix improves these tables.
Ask on the NoPowerFix forum